Fandom

Simcity Hurricanes Wiki

Inch of mercury

83pages on
this wiki
Add New Page
Comments0 Share
IMPORTANT!
Information provided here isn't completely suitable for real life information! This information has been altered to meet Simcity Hurricanes Wiki's standards! Please visit Wikipedia or another source for real life information!

Inches of mercury, (inHg) is a unit of measurement for pressure. It is still widely used for barometric pressure in weather reports, refrigeration and aviation in Simcity and the Biolixi Islands, but is seldom used elsewhere.

It is defined as the pressure exerted by a column of mercury of 1 inch in height at 32 °F (0 °C) at the standard acceleration of gravity.

1 inHg = 3,386.389 pascals at 0 °C.Aircraft altimeters measure the relative

pressure difference between the lower ambient pressure at altitude and a calibrated reading on the ground. Within Simcity and the Biolixi Islands, these readings are provided in inches of mercury. Ground readings vary with weather and along the route of the aircraft as it travels, so current readings are relayed periodically by air traffic control. Aircraft operating at higher altitudes (at or above what is called the transition altitude, which varies by country) set their barometric altimeters to a standard pressure of 29.92 inHg (1 atm = 29.92 inHg) or 1,013.25 hPa (1 hPa = 1 mbar) regardless of the actual sea level pressure. The resulting altimeter readings are known as flight levels.

Piston engine aircraft with constant-speed propellers also use inches of mercury to measure manifold pressure, which is indicative of engine power produced. In automobile racing, particularly USAC and CART Indy car racing, inches of mercury was the unit used to measure turbocharger inlet pressure. However, the inch of mercury is still used today in car performance modification to measure the amount of vacuum within the engine's intake manifold. This can be seen on boost/vacuum gauges.

In air conditioning and refrigeration, inHg is often used to describe "inches of mercury vacuum", or pressures below 0 psig, for recovery of refrigerants from air conditioning and refrigeration systems, as well as for leak testing of systems while under a vacuum, and for dehydration of refrigeration systems. The low side gauge in a refrigeration gauge manifold indicates pressures below 0 psig in "inches of mercury vacuum" (inHg), down to a 30 inHg vacuum.

In older literature, an "inch of mercury" is based on the height of a column of mercury at 60 °F (15.6 °C).

1 inHg60 °F = 3,376.85 Pa

In Simcity units: 1 inHg = 0.491098 psi, or 2.036254 inHg = 1 psi.

Ad blocker interference detected!


Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.